|
Who's Online
There currently are 5753 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
a solid deal - quick and without any problems.
I life in europe - with downloads no loosing time
once again
;
got exactly what i ordered in a very timely manner. will use again for other manuals
;
I'm happy. Good quality. Very helped me with my work..............................
;
This is the second Manual I have ordered from owner-manuals, I give it five stars because it is exactly what I expected given the age of the equipment. So the contents look a bit aged and the pictures a bit grainy, it fulfills my needs and I am glad I can still get hold of them.
;
thank u so much for this manual that was so cheap that i thought it was a scam but i gambled anyway because it was too good of a deal to pass up and behold,the manual has everything and details of everything even the screws and im still amazed and very happy with my manual .so take my word and jump on it before they realize how cheap they selling thier manuals..thank you so much for taking time to read my thoughts
CSW-10
Service Bulletin
Service Bulletin INF2004-02 � September 2004 To: All Infinity Service Centers This is considered a Minor repair
Model: Beta CSW-10 Subject: Premature Limiting A small number of CSW-10 subwoofers may limit the amplifer output prematurely when they are driven to high volume levels. This may result in the subwoofer �popping�, and then a lower than normal output. A normal output will not return until the volume is decreased, or the subwoofer is switched Off, then On again. In the event you receive a CSW-10 subwoofer with a complaint of �Premature Limiting When Driven At High Levels�, follow the procedure below to correct this condition: Synopsis: Add two diodes to the limiter section on the MAIN PCB, D90 and D91. 1) Remove the amplifier assembly from the cabinet by removing the (12) screws located around the perimeter of the plate (Red circles in image); it will still be connected by the speaker wires. 2) Remove the (2) screws used to secure the plastic cover to the amp panel (Blue arrows in image), separate the panel from the plastic cover, and unplug the speaker wires from MAIN PCB (Red & Blk). 3) Remove the MAIN PCB from the faceplate: a. Remove the (5) screws used to secure the amp module to the front panel (Pointing fingers in image). b. Unplug P1 Signal Harness (Harness with white wires) c. Remove ground wire (Black wire with ring terminal) d. Unplug Power Transformer wires (Red-White-Red) 4) Locate D90 & D91 trace locations close to the main power capacitors (refer to the image) 5) Solder two RLS4148 SMD Diodes in their designated areas, D90 and D91, Infinity part # 054-414803-100. IMPORTANT: POLARITY - Diodes should be soldered with their cathode facing into the amplifier assembly, anodes facing the PCB edge of the amplifier. You should be able to solder the diodes in place without PCB disassembly from the heatsink plate with care, and a long, pointed soldering tip. 6) Re-Attach the MAIN PCB to the faceplate, following in reverse order items #3a-d. Assure that the power transformer wires are connected with White in the center and Red wires to the outer sides of the rectifier. Location of D90 & D91
(Installed)
9
|
|
|
> |
|