A comprehensive Operating and Service Manual. All schematics are complete and easy to read. The PCB drawings and complete parts list are very helpful. I would definitely recommend this manual.
Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
Text excerpt from page 3 (click to view)
INSTALLING SPIKED FEET
Entra Two and Entra Three
Refer to Figure 4 as you perform the following steps: 1. The Entra Two and Entra Three come with the round end of their feet exposed for use on hard-surface floors.To expose the spiked end of the feet, lay each speaker on its side and use the enclosed wrench to unscrew and remove the four feet. Screw the round end of each foot into its hole and hand-tighten a nut onto each foot. Leave a minimum of 5/8" of exposed spike. (On thicker carpets, you can increase the length of exposed spike up to 1-1/8. ) " 2. Carefully stand each speaker upright to sit on its feet. 3. If needed, adjust the feet so each speaker is level and then tighten each nut with the enclosed wrench.
Bottom of Speaker Locking Nut
5 �8"
min.
Foot
round end spike end
5 �8"
11 �8" max.
Nylon Dome
(optional for wood floors)
CARPETED FLOORS
HARD-SURFACE FLOORS
� This cross section shows how to install a foot onto the bottom of an Entra floorstanding speaker.