The only reason I gave this less than 4 stars, is because it shouldn't take 24 hrs to have the download available. I was surprised to find that I had to wait until the next day to be able to download the manual that I paid for.
The manual itself is the correct manual.
hi owners manual- crew,
i am very satisfied about the trade with you.
if i need some other manuals, i will contact you again.
thanks
frank kappler
Text excerpt from page 6 (click to view)
ERS Series Installation/Owner�s Manual
4. Strip the ends of the speaker wires about 3�8". Twist the wire strands together for terminal insertion. Connect the speaker wires to the appropriate speaker terminals on each speaker, as shown in Figure 3.
IMPORTANT: Make sure you observe the polarity codes (i.e., red is + and black is �).
AMPLIFIER (Rear View)
+ �
use wire with no ridge on jacket or silver wire
�
+
use wire with ridge on jacket or gold wire
ERS 840 (Rear View)
Figure 3. Example of correct wiring connections used on the ERS 840. Other models are wired similarly.
5. Before mounting the speakers, make sure the attached mounting frame is in the extended position (see Figure 2 on page 4). For each speaker, insert the bottom of the mounting frame (and cable) into its respective cavity. Insert the top of the mounting frame into the opening and slide the baffle up to fit the cutout. Equally tighten each of the four Phillips screws (already inserted) to sandwich the mounting frame against the wallboard, as shown in Figure 4 on page 6.
CAUTION: DO NOT OVERTIGHTEN SCREWS! Doing so may damage the assembly.