perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Super nice! Good to have a manual in digital format.
Text excerpt from page 6 (click to view)
ERS Series Installation/Ownerâs Manual
4. Strip the ends of the speaker wires about 3â8". Twist the wire strands together for terminal insertion. Connect the speaker wires to the appropriate speaker terminals on each speaker, as shown in Figure 3.
IMPORTANT: Make sure you observe the polarity codes (i.e., red is + and black is â).
AMPLIFIER (Rear View)
use wire with no ridge on jacket or silver wire
use wire with ridge on jacket or gold wire
ERS 840 (Rear View)
Figure 3. Example of correct wiring connections used on the ERS 840. Other models are wired similarly.
5. Before mounting the speakers, make sure the attached mounting frame is in the extended position (see Figure 2 on page 4). For each speaker, insert the bottom of the mounting frame (and cable) into its respective cavity. Insert the top of the mounting frame into the opening and slide the baffle up to fit the cutout. Equally tighten each of the four Phillips screws (already inserted) to sandwich the mounting frame against the wallboard, as shown in Figure 4 on page 6.
CAUTION: DO NOT OVERTIGHTEN SCREWS! Doing so may damage the assembly.