|
Who's Online
There currently are 5552 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Excellent service from this company (including a total refund on an earlier purchase when through no fault of the company the manual was incomplete). I have purchased several manuals which I have been very satisfied with, as I am with this one. Highly recommended.
;
It was easy to order and received exactly what I needed. Only complaint would be the 24 hours you have to wait.
;
Manual was delivered in a timely manner and was all in English as advertised. The manuals I received when we moved into our flat were in German, Italian, and French. Having never used a steamer before, and not speaking/reading German very well, I needed an English Manual. this was a huge help.
;
Great Manual. This manual is available no where else. It was exactly what I was looking for. Only in German.
;
This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
INSTALLING FEET
IL30 and IL40
Refer to Figure 3 as you perform the following steps: 1. Open each accessory pack and locate the following items: four feet (with spike/round ends), four locking nuts, four nylon domes and one wrench. 2. Lay each speaker on its side and locate the four threaded holes on the bottom. 3. For carpets, screw the round end of a foot into each hole and hand-tighten a nut onto each one. Leave a minimum of 5/8" of exposed spike. (On thicker carpets, you can increase the length of exposed spike up to 1-1/8. ) For hard-surface " floors, screw the spike end into each hole instead and leave 5/8" of round end exposed. 4. Carefully flip each speaker upright to sit on its feet. 5. If needed, adjust the feet so each speaker is level and then tighten each nut with the enclosed wrench.To protect hard surfaces (e.g., wood floors), slip a nylon dome onto each round end.
Bottom of Speaker Locking Nut
5 �8"
min.
Foot
round end spike end
5 �8"
11 �8" max.
Nylon Dome
(optional for wood floors)
CARPETED FLOORS
HARD-SURFACE FLOORS
� This cross section shows how to install a foot onto the bottom of an IL30 or IL40 floorstanding speaker.
FIGURE 3
INTERLUDE
3
|
|
|
> |
|