|
|
|
Who's Online
There currently are 5834 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great Manual. It was exactly what I was looking for
;
I am really satisfied. It was ceap, easy and quick. Te owner manual is a full service book. I got what I expected. Thx
;
The service was good but it just a little late for the download. It seems that it needs to clear the payment but the payment was settled by paypal. As far as my concern, it should be able to download after the confirmation of sold.
;
Great quality manual, fast service, excellent seller... Thanks !!!
;
Great manual and fast service. Download was possible after a few hours.
PS-8 PS-8 Test Set Up and Procedure
SYSTEM AURAL SWEEP TEST Equipment needed: � Function/signal generator/sweep generator � Integrated Amplifier � Multimeter � Speaker cables General Unit Function (UUT = Unit Under Test) Switches/knobs on the amplifier faceplate: Low Pass Frequency Adjust full CW (150Hz) Phase switch � either position 1. From the signal generator, Connect both right and left line level inputs (RCA) � not the LFE jack - to signal generator and UUT. Use Y-cable if necessary from mono source. 2. On the amplifier, turn the LEVEL control full Counterclockwise (Min). 3. Turn on generator, adjust to 75mV, 50 Hz. 4. Plug in UUT; turn the power switch ON. Turn LEVEL control full Clockwise (Max). 5. LED should now be Green; immediate bass response should be heard and felt from rear port tube opening. 6. Turn off generator, turn LEVEL control fully Counterclockwise (Min), disconnect RCA cable. 7. Connect one pair of speaker cables to one set of High Level input terminals on UUT. Cables should be connected to an integrated amplifier fed by the signal generator. 8. Turn on generator and adjust so that speaker level input at the amplifier is 1.5V, 50 Hz. Turn LEVEL control full Clockwise (Max). 9. Green LED should light; immediate bass response should be heard and felt from the port tube opening. Sweep Function 1. Follow steps 7-10 above, using a sweep generator as a signal source. 2. Sweep generator from 20Hz to 1kHz. Listen to the cabinet and drivers for any rattles, clicks, buzzes or any other noises. If any unusual noises are heard, remove woofer and test. Driver Function (Woofer) 1. Remove woofer from cabinet; detach + and - wire clips. 2. Check DC resistance of woofer; it should be 4.5 ohms±10%. 3. Connect a pair of speaker cables to driver terminals. Cables should be connected to an integrated amplifier fed by a signal generator. Turn on generator and adjust so that speaker level output is 5.0V. 4. Sweep generator from 20Hz to 1kHz. Listen to driver for any rubbing, buzzing, or other unusual noises.
9
|
|
|
> |
|
